Norton 5950R - 5900 Series Low Energy Heavy Duty Operator, Pull Side, Right Hand

Description

Description:
The 5900 Series is a full-featured, extremely quiet, low energy door operator designed for moderate to high traffic doors. This cost-effective operator is available for either push- or pull-side mounting and is ideal for any application designed to meet the Americans with Disabilities Act (A.D.A). “One touch” programming combined with the operators' built-in ability to calibrate door mass, offers Norton customers a smart, dependable solution.
Features:
Ease of installation and setup
Simple instructions
"One touch" programming
Application versatility and ease of adjustment
Non-handed units
Push- or pull-side mounting
Interfaces with electric hardware
Integrates with access control system
Operation startup options
Wall switches
Motion sensor
Radio frequency device
Push and Go
Presence Detector input
Sync cable for double doors; synchronizes closing of two operators
Functions:
Power Assist - when unit is activated, it allows the door to be opened manually with a force less than 5 lbs.
Push and Go (selectable) - as the door is manually opened, the operator “senses” movement and opens door to the full-open position.
Obstruction Detection
Open - door closes if it hits an obstruction while opening
Close (Stop on Stall) - door will stop once it hits an obstruction and rest against the obstruction until obstruction is removed
Motor Startup Delay - delays operator opening
Infinite Hold Open - door will hold open at set position until power is turned off
Power Latch (selectable) - increases latch power
Selector mode switch (3 position)
Off - disables signal inputs
On - activates signal inputs
Hold Open - activates the unit to the hold open position
Typical Applications
Senior Housing/Assisted Living Facilities
Cross Corridor Doors
Convention Center
Exhibition Halls
Hospital
Maternity Ward
Patient Room
Office Building
Board/Meeting Rooms
College or University
Main Entrance Doors
Electrical Data
Power input 120 VAC, 60 Hz (+10%, -15%)
Current draw .75A
12VDC @ .5A output, 24VDC @ .25A output, 24VDC @ .4A output
Certifications
UL325 certified
UL10c certified
Americans with Disabilities Act (ADA)
ANSI/BHMA A156.19 certified
Specfications
Door Control (interior) (exterior) closing force shall be adjustable to ensure adequate closing control. Door Operator shall simulate conventional door closer opening and closing forces unless the power operator motor is activated. Door Operator shall have electronic back check to cushion the door speed if door is opened violently. [(Door Operator shall be AUTOMATICALLY ACTIVATED by either a slight push or pull in the direction of opening swing - Push and Go.) (Door Operator shall be SELECTIVELY ACTIVATED by external initiating device, i.e. wall switch, etc.) (Door Operator shall be both AUTOMATICALLY ACTIVATED and SELECTIVELY ACTIVATED.)] Unit shall have delay switches for motor activation, electric lock interfacing, and hold open time. Units shall interface with latch retraction exit devices or similar products and have 12VDC @ .5A, 24VDC @ .25A, 24VDC @ .4A output for connection of electric strike, lock, radio frequency receiver, etc. Unit shall have a three-position Selector Mode Switch that will permit the unit to be switched “ON” to monitor for function inputs, switch to “H/O” for infinite hold open function or switched “OFF” which will disable function inputs allowing unit to be used as a manual door closer. Unit shall be U.L. Listed for automatic closing door. The Unit shall be adjustable to provide compliance with the requirement
of the Americans with Disabilities Act (ADA). Unit shall be certified by BHMA to meet A156.19 requirements. Unit shall meet UL325, UL10C standards.
Compare the price : 44 To 50